General 15-005S, Setup & Operation Manual

Page: 9 / 22

9
Note: Position the sanding head onto the base so that
the motor is on the right side of the front of the base.
1. With the help of an assistant, place the sand-
ing head on to the base and attach each end
with a hex bolt, lock washer and a medium flat
washer .
2. To facilitate the upcoming assembly steps, reposi-
tion the sanding head from the horizontal (180º) to
the vertical (90º) position. To reposition the head,
push back the sanding head tilting adjustment
lever (under the sanding head) and swivel the
head into the vertical position.
Note: Make sure to pull the lever back to lock the head
in position.
Screw the switch assembly and the table support
bracket into the mounting holes on the end of the
motor, as shown above, using a 4 mm T-handle hex
wrench or a 4 mm Allen key. Then, connect the power
cord from the motor to the inlet plug on the switch
.
Note: The sanding belt and the fence are stored inside
the sanding head to prevent damage in shipping
.
To access the sanding belt and fence, remove the belt
guard
, left drum guard (side opposite the motor)
and dust hood , which are already installed on the
sanding head
INSTALL THE SANDING HEAD ONTO THE BASE
To Lock
To Loosen
The sanding head is heavy. Do not over-exert. The
help of an assistant will be needed for the following
step.
INSTALL THE SWITCH
INSTALL THE SANDING BELT
1. Unscrew the lock knob that retains the left drum
guard. Then remove the guard and put it aside for
now.
2. Unscrew the lock knob that retains the belt
guard and the dust hood, then remove the guards
and put them aside for now.