General 15-005S, Setup & Operation Manual

Page: 10 / 22

3. Remove the sanding belt and the fence that
are stored in the sanding head. Put the fence aside
for now.
4. Install the handle onto the belt tension lever . To
install or change the sanding belt, simply pull the
belt tension lever to the “loose” position
. Then
install the sanding belt and reposition the belt
tension lever back to the “tight” position.
5. Install the sanding belt guard between the 2
rear supports – secure the left side only for now,
using a short lock knob and a large flat washer, as
shown above
.
6. Fit the left drum guard between the support
and the belt guard just installed, using another
large flat washer and short lock knob .
Note: Raise the guards so that the lock knobs can be
tightened at the top of the rear supports, to facilitate
the upcoming assembly steps (so that the dust hood
will not rub or bump against the motor).
7. Attach the right drum guard on the dust hood
with 3 flange screws .
10
Tight - Loose