General 15-005S, Setup & Operation Manual

Page: 8 / 22

1. Using a bolt, washer, and a nut, attach 2 rubber
feet
to the side panels (2) according to
order of assembly . Tighten nuts with either a 12
mm hex socket or 12 mm Allen key.
ASSEMBLY INSTRUCTIONS
3. Install the door handle on the door by follow-
ing the order illustrated in figure
. Install the door
between both door supports, first by inserting the
rod into the hole of the lower door support
,
then, by pulling down on the spring lever , and
placing it in the hole of the upper door support.
4. Install the door stopper with 2 screws , using a
small square head screwdriver.
2. Attach the upper and lower door supports to
the side panels , shown above, using the car-
riage bolts, medium flat washers, lock washers and
nuts.
Note: Make sure the hole in the upper door support
faces downward
, and the hole in the lower door
support faces upward (so that the table rod can be
inserted into the lower door support and the spring
lever can be inserted into the upper door support.)
rubber
foot
nut
bolt
ASSEMBLE THE BASE
DO
OR
stopper washer nut
5. Install the back panel using 2 carriage bolts,
medium flat washers, lock washers and nuts ,
one on each side.
6. Place the shelf in the base and secure using 2
screws, medium flat washers and lock washers.
8
washer