PROBE
The SEEKER 400 CameraScope is supplied already connected to a one-
meter-long flexible-obedient probe. The SEEKER 400 System has a slim
12-millimeter diameter tip. The SEEKER 400-09 system is supplied with an
ultra-slim 9-millimeter diameter probe and the SEEKER 400-05 system is sup-
plied with an superslim 5.5-millimeter diameter probe. Whichever SEEKER
400 system you’re using the other probes are available options and are in-
terchangeable with the base unit. Note that the camera head and probe cable
are waterproof, as are the extensions, which, if firmly connected, will make the
entire probe waterproof.
To remove the supplied probe from the handle (
Fig.8
), turn the collar that con-
nects them in the direction shown on its surface — counterclockwise — and
pull the probe straight out from the
handle. To re-attach the probe, or
attach the extensions, reverse the
process, making sure that the
“alignment key” at the end of each
probe lines up with the flat on its
coupling. Tighten the connections
by turning the collar clockwise.
MONITOR
The other main component of the Seeker 400 system is its
3.5-inch color LCD monitor (
Fig.9
). Because the monitor can
communicate wirelessly with the base unit, it can
show what the probe sees even when the two units
are located as far apart as 10 meters, or 32 feet.
When the monitor is attached to the pistol-grip han-
dle, the two units communicate via hard-wired con-
nections, rather than wirelessly. This improves the
quality of the still images and video captured by the
system.
13
CHARGING THE SYSTEM
Fig.7
Both the LCD display and the pistol-grip handle have internal Lithium ion
rechargeable batteries which can be charged separately or at the same time.
(
Fig.7
)
CHARGING THE HANDLE
To charge the handle, insert one of the split cable plugs from the charger in-
terface cable into the jack on the right side of the handle (#1). There is a
bi-colored charging light just above the thumbwheel to the right (#2): it glows
green when the unit is fully charged, or red when charging.
CHARGING THE MONITOR
To charge the monitor, insert the other split cable plug into the right side port
displaying the charging symbol (#3). The monitor charger jack also has a bi-
colored charging light (#4) that glows red when the unit is being charged and
green when fully charged.
12
#2
Bi
‐
Colored
Charging Light
on Handle
Slide
Monitor to
the right
to remove
from handle
#3
Charging Port
on Monitor
#4
Bi
‐
Colored
Charging Light
on Monitor
Charging Cables Attached to Handle
and Monitor
#1
Charging Port
on Handle
#2
Bi
‐
Colored
Charging Light
on Handle
Keyed Ends
Fig.8
Fig.9
DCS400_NEW_082610_AWB13P:Layout 1 8/26/10 10:47 AM Page 12
