OPERATING INSTRUCTIONS
Always turn on the dust collector before starting your dust producing machine and always stop the dust produc-
ing machine before turning off the dust collector.
BEFORE STARTING
1. To minimize airborne dust make sure that all hoses,
fittings and clamps are secure and airtight.
2. For maximum system efficiency, make sure a cover
is installed on any unused hose inlet openings.
3. Never operate the machine without two filters (bag
or cartridge) and two collection bags properly
installed.
The sound level of this machine is rated at approximately 85-95 dB during operation. Make sure that adequate
hearing protection is used and that the overall sound level within the working environment is taken into consid-
eration.
FIT THE CANISTER FILTERS TO THE DRUMS :
(MODEL 10-510CF ONLY)
1. Fit the canister filters onto the top opening on the
drums,
A
.
Tip/Hint:
To seat the canister on the rim of the drum, run a flat
piece of wood (such as a ruler) between the drum and the black
apron on the bottom of the canister.
2. Use the belt clamp to hold the canister filter secure-
ly onto the drum.
A
INSTALL THE HOSE INLET:
Fit the hose inlet (4-hole manifold) over the main air
inlet, and secure it in place using the 3/16” X 3/8” metal
screw.
INSTALL FOAM GASKETS (IF NEEDED)
Basic assembly is now complete and your dust collector is
ready to be put into service. Once the unit is hooked up to
an appropriate electrical connection, check for air leaks
around the bags or canisters (model 10-510CF). If neces-
sary to seal an air leak, peel off the backing and stick the
adhesive foam gasket onto the drum, making sure the
gasket is sitting in the appropriate groove on the drum.
12