INSTALLING THE FAN/MOTOR ASSEMBLY ONTO THE BASE:
Tip/Hint
: Have 2 people turn the collector body right
side up (See Fig. 12) and support the weight while the
third person aligns and attaches the legs to the base.
1. Connect the legs from collector body with fan
& motor assembly to the base using 8 x 5/16” x
1/2” hex bolts (2 per leg,
A
). Be sure to tighten the
bolts securely.
A
FITTING THE RUBBER GASKETS TO THE DRUMS:
To mount the gaskets to the outlets on the 2 drums, slip
(3) 5/16” x 1” hex bolts through the top holes of the
drum outlet to help hold and align the gasket.
Note: Fit the gasket to the outlet with the flat surface
facing out and the ridged surface against the outlet on
the drum.
ATTACH THE DRUMS TO THE COLLECTOR BODY:
A
B
Note: Help with lifting will be needed at this time.
Using 2 wrenches attach the drums to the collector
body and fan assembly using (16) 5/16” x 1” hex bolts,
32 washers and 16 nuts,
A
&
B
. Be sure to tighten the
bolts securely and make sure the gasket stays aligned.
(See
C
for order of assembly)
nut
washer
collector
body
gasket
drum
outlet
washer
bolt
C
10
INSTALL THE VERTICAL SUPPORT RODS:
Attach the vertical support rods to each end of the
base and to each drum using (8) 5/16” x 1/2” hex
bolts as shown.
