10
4.
Insert a carriage bolt
C
into each hole located in
the support panel sides.
3.
Insert a bolt
B
into each hole and secure the sup-
port using a flange nut
C
and a 9 mm wrench.
Then repeat steps 2 and 3 with the second support
panel.
B
C
C
5.
Slide the cross panel
D
onto the carriage bolts and
secure it in place using the flange nuts
E
and a 13
mm wrench.
6.
Make sure the frame is assembled as shown.
D
E
BEFORE ASSEMBLING, MAKE SURE THAT THE SWITCH IS IN THE “OFF” POSITION AND THAT THE POWER CORD IS
UNPLUGGED. DO NOT PLUG IN OR TURN ON THE MACHINE UNTIL YOU HAVE COMPLETED THE ASSEMBLY AND
INSTALLATION STEPS DESCRIBED IN THIS SECTION OF THE MANUAL.
ASSEMBLING THE FRAME (CONTINUED)
INSTALLING THE CASTERS
1.
Insert a wheel into the mounting holes located in
each corner of the base, and secure it by tighten-
ing a nut
A
using two 17 mm wrenches.
Note: The two swivel casters must be installed in the front
of the machine B while the two lockable swivel casters
must be installed in the back C.
B
A
B
C
