General Dynamics 500-0646, Operation Manual

Page: 43 / 57

500-0646A 34
Figure 28. Elevation Resolver Assembly
2.2.15 Installing the Azimuth Transducer
CAUTION! TO PREVENT DAMAGE TO THE JACK OR INJURY TO THE
OPERATOR, CARE SHOULD BE TAKEN TO DRIVE THE JACK
SLOWLY AS IT APPROACHES THE STOP COLLAR AT THE LIMITS
OF ELEVATION TRAVEL.
Step 1. Drive the azimuth jack until it is fully retracted.
Step 2. Attach the mount bracket to the lower pintle shaft of the pedestal with the bolt. See
Figure 30.
CAUTION! DO NOT OVER-TIGHTEN THE SETSCREWS AGAINST THE
RESOLVER OR DAMAGE MAY OCCUR.
Step 3.
Insert the resolver into the resolver bracket and secure with cleats.
Step 4. Line up the bracket as shown in Figure 29 and Figure 30 and attach the swing arm
clamp to the resolver shaft using the setscrew and tighten.
Note: Additional adjustment may be necessary when installation is complete.
Step 5. Attach the swing arm to the swing arm clamp with the setscrew. Adjust the length of
the arm to properly fit the pivot hardware as seen in Figure 29 and Figure 30. Adjust
the length of the arm so that it lines up.
Note: Swing arm should be parallel with mount when adjusted.