500-0646A 21
Step 4.
Loosely attach two feed boom standard mount channels to the top of the feed booms
with 3/8" x 1-3/4" [9.525mm x 44.45mm] stainless steel hardware and install the 1/2"
[12.7mm] plastic shims between the top of the boom and the bottom of the
standard-mount channel (see Figure 16).
Figure 15. Rotating Antenna for Feed Boom Installation
Step 5.
Loosely attach the other two feed boom standard-mount channels and long feed
boom diagonal braces to the bottom of the feed booms with 3/8" x 1-1/4" stainless
steel hardware, (see Figure 17).
Step 6.
Loosely install the short feed boom diagonal brace inside the rear section of the feed
booms. It attaches underneath the hub weldment with 3/8" x 1-1/4" [9.525mm x
31.75mm] stainless steel hardware between the feed booms and the angle clips, and
1/2" x 1-1/2" [12.7mm x 38.1mm] stainless steel hardware between the angle clip and
brace. (
This member is only for manual pedestal models
). (See Figure 17).
Summary of Contents for 500-0646
