USER MANUAL
GWR Router Series
50
Serial Port Settings
Label
Description
Enable configuration
console
Enable router configuration console. Default serial port parameters are: Serial
port parameters: baud rate - 57600, data bits - 8, parity - none, stop bits - 1, flow
control - none.
Enable serial-Ethernet
converter
Enable serial to Ethernet converter. This provides a way for a user to connect
from a network connection to a serial port.
Bits per second
The unit and attached serial device, such as a modem, must agree on a speed or
baud rate to use for the serial connection. Valid baud rates are 300, 1200, 2400,
4800, 9600, 19200, 38400, 57600 or 115200.
Data bits
Indicates the number of bits in a transmitted data package.
Parity
Checks for the parity bit. None
is the default.
Stop bits
The stop bit follows the data and parity bits in serial communication. It
indicates the end of transmission. The default is 1.
Flow control
Flow control manages data flow between devices in a network to ensure it is
processed efficiently. Too much data arriving before a device is prepared to
manage it causes lost or retransmitted data. None
is the default.
Bind to port
Number of the TCP/IP port to accept connections from for this device.
Type of socket
Either raw, brawl or telnet. raw enables the port and transfers all data as-is
between the port and the long. rawlp enables the port and transfers all input
data to device, device is open without any termios setting. It allows using
printers connected to them. telnet enables the port and runs the telnet protocol
on the port to set up telnet parameters. This is most useful for using telnet.
Reload
Click
Reload
to discard any changes and reload previous settings.
Save
Click
Save
button to save your changes back to the GWR Router and
activate/deactivate serial to Ethernet converter.
Table 16 - Serial port parameters
www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
