Gemm New Runner BCB/05US, Instructions For Use Manual

Page: 25 / 44

BCB US Rev.00 01-2019 pag. 25
The buttons on the control panel are as follows:
BUTTON 0/1,
START/STOP
With the machine OFF (0) press once to go to
STANDBY (1). With the machine on STANDBY press
once to START a cycle. When a cycle is in progress
press once to STOP it. In whatever situation the
machine is, if the button is held down for 3 seconds
the circuit board is cut OFF.
- AND + BUTTONS
Used to increase or decrease the value shown on the
display.
DEFROST BUTTON
With the machine on STANDBY and/or during the
storage, press once to start a defrost cycle.
CHILLLING BUTTON
With the machine on STANDBY press once to select
a time controlled chilling cycle.
Keep held down the button for 3 second in order to
start the continuous cycle
HARD/SOFT BUTTON
With the cycle selected, press once in order to select
HARD or SOFT process.
FREEZING BUTTON
With the machine on STANDBY press once to select
a time controlled freezing cycle.
AUXILIARY BUTTON
Press this button in order to use the accessory, as UV
lamp, warmed probe, where installed.
The icons on the control panel display are:
OFF
Illuminated when the machine is OFF; not illuminated in all other
situations.
FAHRENHEIT / CELSIUS
Can be illuminated in red or green to indicate the temperature
measuring unit.
CHILLING AND FREEZING
Flash when the cycles they refer to are in progress; remain
illuminated during the following holding cycle.
TEMPERATURE
Illuminated during a temperature controlled cycle
TIME
Illuminated during a time controlled cycle.
HOLDING
Illuminated or flashing during the holding period.
CONTINUOUS CYCLE
Illuminated or flashing during the pre-cooling phase, also
CONTINUOUS CYCLE.