8.0 - PINOUT TABLE
ATTENTION
!
This alarm system is intended for 12V turn indicators.
sure the flashers are powered by a
12V signal.
Before you do any electrical work, make
Wire function
Wire color
Pos.
- 1 -
- 2 -
- 3 -
- 4 -
- 5 -
- 6 -
- 7 -
- 8 -
- 9 -
- 10 -
- 11 -
- 12 -
- 13 -
- 14 -
- 15 -
- 16 -
Brown (2-pin connector)
Brown
(2-pin connector)
White-Violet
Green-Brown
---
---
Yellow
Black
Green
Grey
White
White-Grey
Orange
Red
Orange
Black
N/A
Power supply earth ground
Turn indicators (12V)
Positive supply
Turn indicators (12V)
Negative output during alarm
N/A
N/A
Ignition
LED
N/A
Contact switch input
Immobilizer (N.O.)
Immobilizer (Com.)
Immobilizer (N.C.)
Antenna
negative output
Alarms are supplied without wiring harnesses. A wide range of specific pin-
to-pin wiring harnesses is available for the most common motorbikes.
KITCA 417N17.
The following tables refer to the generic wiring harness
Attach to cut end of key switch wire
Attach to cut end of main wiring harness.
.
Connect to a permanent negative connection
(do not connect to vehicle chassis
Connect to the cable end which, if grounded, will kill
the engine.
).
IMMOBILIZER - cut wire
IMMOBILIZER - grounded wire
Wire color
Wire color
White
Grey
White
White/Grey
Connections
Connections
Disconnect the negative battery
terminal before making any electrical
connections and only reconnect it once all connections are completed.
WARNING
!
PAGE 8
PAGE 9
