9.14 -
:
pas#password#x,0#
x 0
1
0
pas ok
= or (0=OFF; 1=ON) to enable/disable passive arming.
= factory reserved parameter, do not modify.
When requested by the user, the system sends a receipt confirmation
message (ex.:
, if the feature has been enabled).
The system will automatically arm 2 minutes after ignition is turned OFF .
SYSTEM PASSIVE ARMING
9.15 - PERIODIC POSITION CONTROL:
9.16 - AUXILIARY INPUT CONFIGURATION:
pos#password#180#
aux#password#n
This f
is ONLY available when the system is armed.
The last 3 digits “180” indicate the number of minutes after which the system
checks vehicle position (selectable between 1 and 999 minutes).
After the selected period (in this case 180 min.), the tracking unit checks the
vehicle position and, if it turns out to be different from the one previously saved,
it will send an SMS to the registered phone numbers (as in case of an alarm
condition).
The message will ONLY be sent if ignition key is “OFF” during the set period.
If ignition is turned “ON”, the countdown will start again once ignition is turned
“OFF”.
To disable this function, set: “000” (three zeros).
Letter “n” indicates a numerical value from 0 to 9 (
nstaller manual).
This command is used to configure the auxiliary input according to the
connection made by the installer.
Programming of auxiliary input should not be modified. Ask your installer about
the operation procedure as well as the correct and appropriate use of the
system.
eature
see table in I
ATTENTION
The system is factory set with
.
passive arming disabled
