Cinterion
®
LTE Terminals Hardware Interface Description
3.6 GPIO Interface
47
ELSxT_HID_v04
2018-09-04
Confidential / Preliminary
Page 35 of 102
single channel PCM CODEC chip (AK2300), has a fixed terminal block (green connector) in
order to connect easily to the Terminal ELS61T-E2 and a 3.5 mm plug connector for the head-
phone.
The DAI Interface supports following configurations:
•
256 kHz long frame synchronization master mode
•
16 Bit linear
•
8 kHz sample rate
•
The most significant bit MSB is transferred first
•
Data write at rising edge / data read at falling edge
•
Common frame sync signal for transmit and receive
Figure 15:
Audio Codec Board
The signal “Call Button” indicates the state of the Call Button on the headphone and should be
connected to GPIO.
3.6.2.3
Manual configuration via AT-Commands
Following steps have to be done:
•
Connect the Terminal with the PC via RS-232 Interface.
•
Open for instance an HTerm and open Port (115200, 8N1, no flowcontrol).
•
enter following AT commands:
•
at^scfg="Gpio/mode/DAI","std" //
set
GPIOs in the module to DAI functionality
•
at^sspi=
// open I2C connection
•
<aD41601>
// set GPIO 22 to output (TFSDAI)
•
<aD41701>
// set GPIO 23 to output (SCLK)
•
<aD41800>
// set GPIO 21 to input (RXDDAI)
•
<aD41901>
// set GPIO 20 to output (TXDDAI)
DOUT
DIN
GND
VREF
5V
BCLK
FSC
Call
Button
Head-
phone
3.5 mm
Activity
LED