GEM genesys s, Release Notes

Page: 10 / 32

MULTIPEDAL MODE
The multipedal is a new optional accessory unit specifi cally designed for Genesys. This unit has six pedal
switches. All six may be used with the simple connection of only one pedal input: leaving the remaining
two available for volume and sustain.
Press the [PRESET] button in SECTION EDIT 1
To access the MULTIPEDAL mode functions, the optional MUL-
TIPEDAL unit has to be connected to the Genesys.
NOTE:
In this example we assume the MULTIPEDAL is con-
nected to the input N. 1 on the rear panel. If you
have Connected the MULTIPEDAL to a different
input, you will have to select the correct one.
Press the function button [B] or ENTER to enter
the menu
2
DAMPER, SOFT and SOSTENUTO can not be assigned to the
single switch pedal in MULTIPEDAL mode.
NOTE:
Select MULTIPEDAL in the pedal 1 fi eld 3
Press the function button [F5] MULTIPEDAL 1 4
The display shows the MULTIPEDAL assign
screen
Select the function you want to recall with each
pedal by rotating the DIAL.
4
It is also possible to check the function assigned
to the pedal simply pressing the relative foot-
switch.
Select another footswitch by using the CURSOR,
then select the desired function with the data
DIAL.
5
Repeat the operation until the six footswitches
are assigned to the functions you wish them to
control.
Up to 3 MULTIPEDAL unit can be connected at the same time
to the Genesys pedal input
multipedal mode Page6
release notes
Genesys series