GEL Decal 110, Operation And Maintenance Manual, Page: 83 / 228

ENGLISH
83
The Timer VT 2000 Duplex is supplied already programmed with the following values:
Time: current time
Regeneration: volume/ time
Days between the two regenerations: 4
Regeneration hour: 02
Water hardness at the entry: 50° f
Water hardness at the outlet: 15° f
Vessel A: ON (operation)
Vessel B: OFF (stand-by)
Except for the clock and the exhausted salt alarm, all the other operating parameters
of the softener are to be adjusted by the authorized Technical Assistance Service
carrying out the first start up and testing of the softener.
The user and/or the installer are not allowed for any reason to change these
programming parameters!
The programming of this Timer is the same as the Timer VT 2000 (see section 13)
ADDITIONAL INSTRUCTIONS FOR DUPLEX SOFTENERS
When timers switch on, the following is displayed:
- the display of the SLAVE Timer will show Slave
- the display of the MASTER Timer will show the following:
indicating that:
- vessel A (corresponding to MASTER timer) is in operation
- vessel B (corresponding to SLAVE timer) is in stand-by
14.1 OVERFLOW FUNCTION
When the requested water flow rate exceeds the maximum flow rate the softener can supply, the display
of the timer A MASTER will show the following:
1
CLOCK . . . . . . . . . . . . . . . . . . .17:20
REG . TIME DD =4 H=02
IN= 28 °F OUT= 15 °F
TO CHANGE PRESS A
A = ON B = OFF
2
CLOCK . . . . . . . . . . . . . . . . . . .17:20
REG . TIME DD =4 H=02
IN= 28 °F OUT= 15 °F
TO CHANGE PRESS A
A = OVERFLOW B = OFF