6
Gerhard Geiger GmbH & Co. KG | 100W2507
0220
V001
en
EN
EN
7.
Identification number
Four removable ID stickers are applied on the connecting cable
of the motor
GSI56.. E12 SMI
. The printed number SMI-KEY-ID
clearly identifies the motor in the bus system.
The stickers and / or the connecting cable must not be
interchanged.
The stickers are useful if you want to note the installation location
for a later bus integration of each motor (see “for your notes”).
8. Information for the specialist electrician
H
Caution: Important installation instructions.
Please follow all installation instructions since incorrect installation
can lead to the destruction of the motor and the switching unit.
H
Attention! The bus voltage is not a safe low voltage. The bus is not
galvanically isolated from the supply voltage.
H
The motor can only be operated with SMI certified actuators.
• For the operation with a setting switch, a locking switch is necessary (no simultaneous
UP and DOWN commands).
• The operations with the service clamps may be accomplished only by an electrical
specialist.
• The number of motors which can be connected to an actuator depends on the actuator.
Please observe the instructions of the actuator manufacturer.
•
In case of parallel connection, the maximum load of the electrical installation must not be
exceeded.
• By push-button operation the switchover must be effected through an off position.
•
By push-button operation the switchover time must be at least 0.2 s.
• Connecting cables with plug connectors of the Hirschmann Company are tested and
approved with couplings of the Hirschmann Company.
• A 5-pole connecting cable with continuous power supply must be used for SMI motors.
(GEIGER Flat5 with dark blue ring)
• In order to prevent a malfunction caused by coupling, the supply line (ref. NYM) from the
actuator/switch to the motor must not exceed 100m in case of motors with electronic end
stops.
SMI-KEY-ID:
1114166510
SMI-KEY-ID:
1114166510
SMI-KEY-ID:
1114166510
SMI-KEY-ID:
1114166510
SMI-KEY-ID:
1114166510
