10
Gerhard Geiger GmbH & Co. KG | 100W2507
0220
V001
en
EN
EN
12. Setting of the end stops
General information
In order to set the end positions of the
GSI56.. E07 SMI
motors, any setting switch – with
continuous power supply – can be used that has a programming key or that allows a
simultaneous UP/DOWN command. In this case, the UP/DOWN keys must be activated
simultaneously instead of the programming key.
Article number / GEIGER setting switch
M56F152
with service terminal (D), 5 wires, SMI compatible
M56F153
with service terminal (CH), 5 wires, SMI compatible
I
Important: please observe the connecting diagram on the back of the
setting switch.
Factory setting
• The motor is set on the upper end position at the factory. The lower end stop is at the very
other end. (at least lower end stop + 200 motor rotations).
• The motor command is in normal operation.
I
If the factory setting has been carried out and if the programming
mode is activated, max. 100 revolutions can be done downwards.
Reset to factory settings for a further run downwards.
13. Activate the programming mode
I
Prerequisite: The motor is positioned between the upper and the
lower end position.
I
The GSI56.. E12 SMI can be set with any SMI setting switch that
ensures a continuous power supply and has a programming key
or that allows a simultaneous UP/DOWN command. If there is no
programming key, the UP/DOWN keys must be simultaneously
pressed.
Activate the programming mode
via limit stop switch
In order to activate the programming mode, the motor
must be connected according to the diagram “push
button operation” (see point 8).
Press the programming key of the limit stop switch or the
UP/DOWN keys simultaneously until, after about 3 seconds,
the motor confirms “end position programming activated”
with 1 x click-clack. Then release the key.
1 x
Press programming
key for about
3 seconds
Click-clack
PROG
PROG
