11
www.geiger.de
EN
EN
14. Programming/changing the end stops
The upper and lower end stops can be programmed and changed independently
of each other.
• Activate the programming mode.
• Run the motor in the direction of the desired end
position. The motor interrupts its run just to show that it
is in the programming mode:
• The direction in which the motor moves after the break*
determines the end stop to be programmed.
(UP = upper end stop, DOWN = lower end stop)
• When the desired end position is reached, move the
motor in the opposite direction until 2 short breaks*
show the last saved position.
• The programming is completed.
* As long as the interruption of movement has not yet
occurred, corrections can be done.
Start the setting process again to adjust another end position.
Cancel the programming mode:
In order to cancel the programming mode, press the PROG key or press simultaneously the
UP/DOWN keys until the motor confirms the cancellation of the programming mode after about
3 seconds with 2 x click-clack.
15. Resetting to factory settings
Press the programming keys (PROG key, /UP/DOWN keys) about 10 seconds until the motor
jerks 1 x after 3 seconds, 1 x after 6 seconds and 4 x after 10 seconds. Then the motor is reset
to factory settings.
Note: the position at which the drive has been reset to the factory setting is now defined as the
upper end position and can be adjusted by activating the learning mode.
16. Obstacle detection and anti-freeze protection
For an optimal operation of the obstacle detection function, move the blind from bottom to top
without interruption, after the programming has been completed.
After an obstacle detection (e.g. obstacle or blind frozen to the window sill), the UP direction is
blocked.
A short command in the DOWN direction releases the UP direction.
17. What to do if…
Problem
Solution
Motor does not run.
• Motor not plugged in.
Please check the plug connection.
• Check connecting cable for possible
damage.
• Check the mains voltage and allow the
cause of the voltage break down to be
tested by a specialist
electrician.
Instead of in the downwards direction,
motor runs upwards.
• The control leads are interchanged.
Exchange black/grey control leads.
Motor only runs in one
direction.
• Motor in the end position.
Run motor in the opposite direction.
Readjust the end positions, if necessary.
After running several times,
the motor breaks down and
no longer responds.
• The motor became too hot and has
switched off.
Try it again after a cooling time of about
15 min.
PROG
PROG
