Gehl V270, Operator'S Manual

Page: 66 / 102

62 917387/BP0310
Refer to the Maintenance Interval chart (page 81) for change intervals. Refer to
the Replacement Parts chart (page 52) for filter part numbers.
Refer to the Engine Operator’s Manual for detailed engine information.
Checking Engine Mounting Hardware
All bolts that secure the engine mounting brackets to the engine and the loader
frame should be checked and re-torqued as necessary. Refer to the
Torque Speci-
fications Chart (page 91) for torque information.
Allow hot engine and hydraulic system com-
ponents to cool before servicing.
Checking Engine Oil Level
Open engine cover (page 53), pull out the dipstick and check the oil level. Mark-
ings on the dipstick represent FULL and LOW (add oil) levels.
Changing Engine Oil and Filter
Note: For new units, the initial oil change should be after the first 50 hours.
Important: Always dispose of waste
lubricating oil according to local regula-
tions or take to a recycling center for dis-
posal; do not pour onto the ground or
down the drain.
The engine oil filter is located on the left
side of the radiator.
Access for draining the engine oil is
located behind the left rear tire.
To add new oil, open the engine access
cover. Remove the oil fill cap and add the
recommended type and quantity of oil.
Refer to the
Lubrication chart, page 55.
Visually inspect the remote oil drain hose for damage or leaks.
Changing Fuel Filter
The fuel filter located is on the left side of the engine, by the battery. Raise the
ROPS/FOPS and follow the ROPS/FOPS and Lock Mechanism procedure
(page 54) to the ROPS/FOPS and access the filter clean dirt from around the
filter head. Close fuel valves on tank and separator to stop fuel flow BEFORE
replacing the filter. Remove the spin-on filter cartridge. Install the new cartridge
start the engine and check for leaks. See page 61.
WARNING
Figure 34 Remote Engine
Oil Drain