Gehl V270, Operator'S Manual

Page: 35 / 102

917387/BP0310 31
Right Panel
1. Fuel Level Gauge – Displays the amount
of fuel in the tank.
2. Engine Coolant Temperature Gauge –
Displays the temperature of the engine
coolant.
3. Parking Brake Switch – Used to manu-
ally apply the parking brake. Lights
when the parking brake is applied.
4. Front Wiper/Washer (optional) –
5. Rear Wiper/Washer (optional) –
6. Hourmeter – Displays the total operat-
ing hours of the loader.
7. Keyswitch – In a clockwise rotation, the
positions are:
• OFF Position – With the key verti-
cal, power from the battery is discon-
nected from the controls and
instrument panel electrical circuits.
This is the only position from which
the key can be inserted or removed.
• ON (or RUN) Position – With the
key turned one position clockwise
from vertical, power from the battery
is supplied to all control and instru-
ment panel circuits.
• START Position – With the key
turned fully clockwise, the electric
starter engages, to start the engine.
Release the key to RUN position
after the engine starts.
Note: The engine cannot be started unless
the operator is sitting in the seat and the
restraint bar is lowered.
8. Power-A-Tach
®
System Switch – Used
to actuate the Power-A-Tach
®
Sys-
tem.Used with the Power-A-Tach Sys-
tem Energize Switch (page 29, Number
7) Press the top of the switch to retract
(release) the hitch pins; press the bottom
of the switch to extend (engage) the
hitch pins.
9. Engine Speed Control – Controls the engine speed. Move the control clock-
wise to increase and counter-clockwise to decrease the engine speed.
1 2
3 4
Figure 12 Right Panel
8
5
7
6
9