Fig. 4
1.
Spray Tank Fill Cap
2.
Battery
3.
Hydraulic Reservoir Fill Dipstick
4.
Alignment Guide (Ea. Side)
Engine Throttle:
This controls the Engine speed. Idle
position is with the Cable fully in. Operating position
is with the cable 1 to 1-1/2 inches out. Release the
Lock Ring, depress the red button on the Knob and pull
the Knob out to set speed. Rotate the Knob left or right
to fine adjust the speed during operation.
Horn Buttons:
The Horn may be activated from a
Pushbutton on the left side or right side of the Console.
Fuel Level Gauge:
Indicates the amount of fuel
remaining in the Fuel Reservoir.
Battery Charge gauge:
Indicates the condition of the
charging system. During normal operation, this
Indicator should show minimum registeration.
Coolant Temperature Gauge:
Indicates Engine
coolant temperature. Under normal operating condi-
tions, this Gauge should indicate approximately 185
o
F
(85
o
C).
Engine Oil Pressure (1649):
This Lamp indicates
whether sufficient Engine lubricating oil pressure is
present or not. During normal operation, with the
Engine running, this Lamp should be OFF. During
starting and when the Engine is NOT running, this
Lamp will be ON
NOTE:
If this lamp comes ON during normal
operation with the Engine running, STOP the
Engine immediately. After allowing the oil to drain
down for a few minutes, check the Engine oil
level. Maintain oil level at the FULL mark on the
dipstick
Circuit Breaker (1639):
The 15 Amp Breaker protects
electrical circuits. If it is not in the “depressed posi-
tion”, the Gauges and Indicators on the Control Panel
will not work and the Engine will shut off.
Hourmeter:
Indicates the operating time of the
machine and should be used for keeping up the
Maintenance Log chapter of this manual.
Washdown Sprayer System:
Sprayer is used periodi-
cally each day to wash down parts of the Paver which
contact asphalt. An asphalt releasing agent is used for
this.
Exhaust Diverter:
Pull this Cable Handle OUT to
divert the Engine exhaust down through the Screed.
This heats up the Screed bottom surface when paving.
Push Handle IN to divert exhaust out through the
Muffler.
Fuel Level Gauge:
The Gauge needle pointer indi-
cates the amount of fuel remaining in the Reservoir.
CAUTION
Do NOT spray releasing agent on a HOT
Engine.
1
2
3
4
907389/AP297
18
Printed In U.S.A.
Discount-Equipment.com
