![background image](http://html1.mh-extra.com/html/gehl/powerbox-1639/powerbox-1639_operators-manual_2205869011.webp)
SAFETY
(Continued)
z
Some illustrations, used in this manual, may show
Doors, Guards and Shields open or removed for
illustration purposes ONLY. Be SURE that all
Doors, Guards and Shields are in their proper oper-
ating positions BEFORE starting the Engine to
operate the Paver.
z
ALWAYS wear appropriate personal safety gear
called by the job or working conditions. Do NOT
wear loose or baggy clothing while operating or
servicing the machine.
z
ALWAYS maintain safe clearance from electrical
powerlines and avoid contact with any electrically
charged conductor. Contact can result in electrocu-
tion. Contact proper local authorities for utility line
location BEFORE starting a job.
z
ALWAYS check the job site for obstructions and
bystanders!
z
NEVER use your hands to search for hydraulic
fluid leaks. Use a piece of paper or cardboard.
Escaping fluid under pressure can be invisible and
can penetrate the skin causing serious injury. If any
fluid is injected into your skin, see a doctor at
once. Injected fluid MUST be surgically removed
by a doctor familiar with this type of injury or gan-
grene may result!
z
Do NOT attempt to move HOT asphalt mix with
your hands or feet. Contact can cause serious skin
burns!
z
Do NOT allow minors or any unqualified person-
nel to operate or be near the Paver unless properly
supervised!
z
Do NOT operate the Paver in an enclosed area
without adequate ventilation! Internal combustion
engines deplete the oxygen supply within enclosed
spaces and may create a serious hazard unless the
oxygen is replaced!
z
Do NOT leave the Paver unattended with the
Engine running. ALWAYS lower the Hopper to
“full down” position, shut off the Engine and place
all controls in neutral BEFORE leaving the
machine!
z
ALWAYS position the Safety Props when leaving
the Hopper raised for inspection, cleaning or ser-
vice!
z
Do NOT attempt to refill the Fuel Reservoir when
the Engine is hot. Allow Engine to cool down
BEFORE refilling to prevent hot Engine from
igniting the fuel if it should spill or splash!
z
Do NOT smoke while filling the Fuel Reservoir,
while working on the fuel or hydraulic systems, or
while working around the Battery!
z
Do NOT attempt to loosen or disconnect ANY
Hydraulic Lines, Hoses or Fittings without first
relieving hydraulic circuit pressure. Also, be care-
ful NOT to touch any hydraulic components that
have been in recent operation because they can be
extremely HOT and can burn you!.
z
ALWAYS disconnect the Battery connection to
prevent unintentional starting while working on
this machine!
z
Do NOT attempt to remove the Radiator Cap after
the Engine has reached operating temperature or if
it is overheated. At operating temperatures, the
Engine Coolant will be extremely HOT and under
pressure. ALWAYS wait for the Engine to cool
down before attempting to relieve pressure and
remove the Radiator Cap. Failure to heed this
warning could result in severe burns!
z
ALWAYS observe the following Safety
Procedures when Propane Screed Heater is used:
Wrench tighten all fittings. NEVER use grease or
lubrication. Do NOT use oxygen with the Heater.
Keep cylinder upright at all times. Keep equipment
free from dirt and oil.
Use a regulator on supply cylinder.
Check equipment carefully each time before light-
ing. ALWAYS light with a striker, NEVER with
matches. Do NOT operate in an enclosed area or
Printed In U.S.A.
11
907389/AP297
Discount-Equipment.com