10
●
The air flow and pressure can be adjusted steplessly using the rotary knob. The Blower
can thus be adapted to the material to be sprayed. The spray consistency of the material
must be determined beforehand in order to select the best possible settings for the
Blower and spray gun. A dipping cup is supplied with the spray unit for this purpose; see
operating instructions for PN 2 or PN 5 spray guns, depending on which one you’ll
choose, for further details. It is recommended to spray samples before work is started
(e.g. onto cardboard or wood). Do not start work on the actual object to be sprayed until
the desired result is obtained with the samples.
●
Ensure that the edges or borders of the object to be sprayed are properly masked.
7
Switching off the Motor Blower
After you have finished spraying, turn off the Blower by pressing the push button with your
thumb. Only then should the Blower be disconnected from the mains. When work has finished,
coil connection cable as shown in figure 1.
8
Care, Maintenance and Repair
Attention!!!
Always switch off your Motor Blower and disconnect from mains,
before carrying out any repair and maintenance work.
Do not use any solvents or aggressive fluids to clean the fan cage.
Repair and maintenance work, or the replacement of the power
cable, should only be carried out by authorized specialist firms or by
us. Addresses of authorized firms can be obtained from us or from
your dealer.
Excepting filter maintenance (see item 8.1), your SG 90 E Blower Motor does not require any
customer servicing to be carried out.
