2
1
Intended Use
The
ABAC
Motor Blower SG 2500 – named in this manual also as Motor Blower or
simply Blower – is intended to be used together with the
ABAC
low pressure spray
guns PN 1, PN 2 or PN 5 to spray and apply paints and lacquers. For spraying you may
use materials approved by paint manufacturers for High Volume Low Pressure (HVLP)
air-spraying technique application. These are for instance:
·
Patina paints, two-component-paints, synthetic resin alkyd paints, acrylic and
dispersion paints, colour effect paints, insulation / inflammation protection, sprayable
wax materials.
Identification number of SG 2500 Motor Blower is BJ 380 502 0000 (100 V),
BJ3805030000 (115 V), BJ 380 501 0000 (230 V).
Always observe and comply with all processing instructions and safety notes provided
by material manufacturers as well the prescriptions of this operating manual.
In any case, only paints and solvents with a flash point above 21
°
C = 70
°
F may be used
for spraying!
The
ABAC
Motor Blower SG 2500 is designed to be operated in connection with PN 1 /
PN 1A, PN 2 / PN 2A and PN 5
ABAC
Spray Guns, which operate in the low-pressure
range up to 0,45 bar.
It is forbidden to connect the
ABAC
Motor Blower SG 2500 to
devices, which are not intended for paint spraying and application,
as well to technically incompatible spray guns.
Any use of the Motor Blower different from described in this manual
is prohibited.
Ambient temperature range for equipment operation is from 0
°
С
to +45
°
С
, relative
humidity must not exceed 80%. Conditions of transportation and storage see Section 5.
