Geely JL481Q, Manual

Page: 64 / 198

Fig. 133 Installing camshaft seal
Fig. 132 Fastening bearing cap bolt
Fig.135 Matching marks Fig. 134 Fix the position of dowel pin of exhaust camshaft
Fig. 137 Tighten bearing cap bolt Fig. 136 Assemble bearing cap
(2) Mount the intake camshaft on the air inlet side
a. Place the exhaust camshaft in a position so that dowel pin rotates to a level that is slightly higher than the top surface of
cylinder head (Fig. 134).
b. Smear multi-purpose lubricating grease onto thrust position of intake camshaft.
c. Engage the gears of intake camshaft with the gears of exhaust camshaft following the mounting mark on each gear.
Make sure not to confuse mounting mark with timing mark. (Fig. 135)
d. When gears mesh with each other, place intake camshaft onto the bottom hole of bearing seat.
e. Install the four bearing caps onto their corresponding positions in arrow direction and sequence numbers (Fig. 136).
f. Smear a thin layer of engine oil onto the thread below the bolt head of bearing cap.
g. Tighten eight bearing cap bolts in several equal operations, with torque of 13 N.m. (Fig. 137)
Dowel pin
Timing mark
Mounting mark
Mounting
mark
60