Geckoplex EP-5, Owner'S Manual

Page: 8 / 16

Important Notes:
●
Programming does not require an expression pedal to be plugged in,
and if one is it will not affect the the programming process in any way.
●
The input GAIN knob and toggle switches are not controlled by preset,
and their positions will not be stored.
Switches in Programming Mode:
All of the foot switches have an alternate function during preset
programming. These functions are as follows:
●
ON will CANCEL programming mode and leave the preset unchanged.
●
PRESET will STORE the settings in steps 4 and 6.
●
TAP will SKIP storing the settings in steps 4 and 6, leaving that side of
the settings as they were. This is very useful when re-programming a
preset to fine-tune it at just one end of the expression pedal, allowing
changes to be made without moving the controls twice.
Programming Steps:
Follow the steps in the table below to program a preset. To program
presets 4-64, replace steps 1 & 2 by sending a MIDI CC #24 message,
where the value is the number of the preset to begin programming.
Step Action
1 Activate the preset to be programmed using the PRESET switch.
2
Press and hold the PRESET switch for 4 seconds to enter
programming mode. The active preset LED will begin to flash.
3
Set the effect knobs and the delay slider to the desired settings for
this preset. Note that if an expression pedal is used, these initial
settings will be for the
heel side position of the expression pedal.
Otherwise, without an expression pedal, these will be the fixed-
mode settings used when the preset is activated.
4
Press the PRESET switch to store the first set of control settings.
The active preset LED will now begin flashing twice.
5
If an expression pedal will never be used with this preset, skip to
STEP 6 , as there is no need to store toe-side control positions.
Otherwise, set the effect knobs and the delay slider to their desired
positions for the
toe side of the expression pedal and proceed to
STEP 6.
6
Press the PRESET switch again to store the preset to memory and
exit programming mode. The active preset LED will flash quickly for
one second to indicate that the preset has been stored, followed by
a return to normal operation with the newly programmed preset
activated.
8
Preset Programming