Geckoplex EP-5, Owner'S Manual

Page: 12 / 16

MIDI
The Geckoplex allows full MIDI control through its MIDI input and output
jacks. It will respond to Program Change (
PC ) and Control Change ( CC ),
and can either receive or generate and send MIDI clock messages.
MIDI Cable Wiring:
A 1/8 inch (3.5mm) MIDI adapter cable may be required to interface with
other equipment that uses 5-pin DIN jacks for MIDI. The Geckoplex
requires Type A adapters wired per the diagram below. Note that for a
male DIN connector, pins 4 and 5 will be reversed from the diagram.
Program Change (PC) Messages:
Send program change messages to change the active preset. Program
change messages will be ignored in SOS mode.
PC# Description
0 Turns off any active preset
1-64 Enables a preset 1-64 (4-64 are only accessible by MIDI)
Control Change (CC) Messages:
Control change messages can be used to set control and switch values
and change modes and some settings. NOTE: Preset changes and
physical control changes will override settings previously set by MIDI.
Control
CC
# Values Description
Effects Control Knobs
Volume
1
0-127 0 – Min, 127 – Max echo volume
Repeats
2
0-127 0 – Min, 127 – Max repeats (100 - runaway)
Tone
3
0-127 0 – Darkest, 127 – Brightest (64 - neutral)
Reverb
4
0-127 0 – No reverb, 127 – Max reverb
Warp 5 0-127 0 – Clean, 127 – Max tape detune
Shift
6
0-127 0 – Max left, 127 – Max right (64 – neutral)
Delay
7
0-127 0 – 50ms, 127 – Max delay time
T
R
S
FEMALE
Data (Sink)
5V (Source)
Shield
12