Gear4music BDK-1, Setup Manual

Page: 6 / 12

6
1.
Take 1x Tom Tom Drum (10”x 8”) and place on
the fl oor with the Gear4music logo on the side
of the drum facing upright.
2.
Using the drum key, undo the 2 tension rods
from the drum lugs. This will release the metal
drum hoop. Put the tension rods and drum hoop
to one side temporarily.
3.
Place 1x 10” Batter Head (with Gear4music logo)
on top of the drum and place the metal hoop
over the head, noting that the tension rod holes
need to line up with the drum lugs located on
the side of the drum.
4.
Using the drum key, screw 5x tension rods into
the drum lugs to an even tension, ensuring any
creases have been removed from the skin. Do
not over tighten.
5.
Turn the drum over and repeat steps 2 – 4 using
the corresponding resonant head (without the
Gear4music logo).
10” TOM TOM DRUM ASSEMBLY
ITEMS REQUIRED:
1x Batter Head for 10” Tom Tom Drum
(with Gear4music logo)
1x Resonant Head for 10” Tom Tom Drum (no logo)
2x Tom Tom Hoops (10”, attached to drum)
10x Tom Tension Rods and Washers
(note – 2x already attached to the drum)
1x Drum Key
13” TOM TOM DRUM ASSEMBLY
ITEMS REQUIRED:
1x Batter Head for 12” Tom Tom Drum
(with Gear4music logo)
1x Resonant Head for 12” Tom Tom Drum
(no logo)
2x Tom Tom Hoops (12”, attached to drum)
10x Tom Tension Rods and Washers
(note – 2x already attached to the drum)
1x Drum Key
1. Repeat steps for 10” tom tom drum assembly.