GEAppliances AZ75E09DAC, Technical Service Manual

Page: 20 / 55

– 18 –
Slide-Out Chassis
Side Removal
Note: If slide-out chassis cannot be removed from
the front, perform the first 4 steps of Front
Removal above and proceed with Side Removal
below.
1. Remove 8 screws and the cabinet side plate.
2. Move the chassis out of the front of the cabinet
approximately 2 inches.
3. Slide the chassis out from the side of the
cabinet.
Pull Chassis
Forward
Slide Out Side
WARNING: Case ground bolt at front of chassis
must be installed to ensure proper grounding of
the unit. Case ground screw on left hand cabinet
side plate and/or right hand cabinet side plate
must be installed to ensure proper grounding of
the unit.
Front Removal
1. Remove 6 screws and the front panel.
2. Remove the 5/16-in. (case ground) bolt
fastening the chassis to the base of the
cabinet.
3. Remove the case ground screw from the left-
hand side cabinet side plate and/or the right-
hand cabinet side plate.
4. Turn 4 screws on the cabinet top plate
counterclockwise to the raise duct connector
to stop.
5. Slide the chassis out of the cabinet.
Cabinet Top Plate
5/16-in. Bolt (Case Ground)
Screws
5/16-in. Bolt (Case Ground)
C
ase Ground Screw
Case Ground Screw