GE Zoneline 4000 Series, Use And Care Manual

Page: 6 / 8

Use This Problem Solver
PROBLEM POSSIBLE CAUSE AND REMEDY
AIR CONDITIONER Power cord plugged in, fuse circuit breaker tripped,
DOES NOT OPERATE
●
Unit Switch cabinet is at OFF.
●
Unit is waiting 3 minutes for pressure to across the compressor.
AIR CONDITIONER
●
Curtains, blinds or furniture blocking air conditioner will air
“DOES COOL
●
Thermostat Control may be set high enough. Slide a lower higher
OR HEAT AS IT
SHOULD”
number. Highest setting should provide maximum cooling.
Air filter dirty, should be cleaned at 30 days. See instructions on page 5.
●
Room may
been
very hot or very when air conditioner was first turned on.
Allow time for it to or warm up.
. Conditioned air be escaping through open furnace floor registers and cold air
returns.
Control, maybe set allowing outside air to enter
the room.
Temperature Limit may be at a setting other than normal. This will
limit the operating ranges. See page .4.
●
Position of the louvers will affect temperature. See page 3.
“BURNING” ODOR
●
Dust accumulating on surface of heating during or storage
AT START OF can cause “burning” at beginning This odor
dissipate. ‘
OPERATION
OPERATING SOUNDS . Relay clicks may be heard when compressor or fan cycles on and off. This is normal.
●
Fan runs continuously when Switch is set at FAN ONLY or Fan Cycle
Switch behind room cabinet is set CONTINUOUS. This is normal. Otherwise,
fan cycles on and off with the compressor or resistance heater.
DISCHARGED AIR
●
Tilt louvers down slightly and them down until condensation disappears.
CONDENSES
WINDOWS
WALLS
If you need more free:
GE
consumer information
6