GE TransPort PT900, User Manual

Page: 99 / 190

Chapter 4. Programming
TransPort
®
PT900 User’s Manual 83
4.7.3a Analog Outputs
To program the ANALOG OUTPUTS , complete the following steps:
1. Open the drop-down list in the MEASUREMENT box, and select either CH1
(Channel 1), CH2 (Channel 2), Average (Average of CH1 and CH2) or
General (General Function List) for the output.
2. Open the drop-down list in the DATA SOURCE box, and select one of the
available data source options from Table 9 below.
Table 9: Available Output Data Sources
Standard Variables
Channel 1 & Channel 2 AVE (Average) GEN (General)
Velocity Velocity AI 1 Current
Volumetric Volumetric AI 2 Current
Standard Volumetric Standard Volumetric AI 1 Value
Mass Mass AI 2 Value
Batch Forward Totalizer Batch Forward Totalizer Power
Batch Reverse Totalizer Batch Reverse Totalizer Forward Energy
Batch Net Totalizer Batch Net Totalizer Reverse Energy
Batch Totalizer Time Batch Totalizer Time User Func 1
Inventory Forward Totalizer Inventory Forward Totalizer User Func 2
Inventory Reverse Totalizer
Inventory Reverse Totalizer User Func 3
Inventory Net Totalizer Inventory Net Totalizer User Func 4
Inventory Totalizer Time Inventory Totalizer Time User Func 5
Diagnostic Variables
CH1 (Channel 1) & CH2 (Channel 2) Only
Sound Speed Angle in Fluid Peak Percent Down
Reynolds K-Factor Gain Up Signal Dynamic
Multi K-Factor Gain Down Signal Noise Ratio Up
Delta T Partial Compression Up Signal Noise Ratio Down
Active Time Up Partial Compression Down Signal Quality Up
Active Time Down Peak Up Signal Quality Down
Amplitude Discreet Up Peak Down Transit Time Up
Amplitude Discreet Down Peak Percent Up Transit Time Down