GE PSC21MGM, Technical Service Manual

Page: 25 / 76

– 23 –
4. With a small flat-blade screwdriver, disengage
the locking tabs of the upper hinge cover and
remove it.
5. Remove the Torx head hinge screws (2) and
lift the upper hinge off the unit.
CAUTION: Do not side-load hinges.
CAUTION: Freezer door only — Do not allow the
connector to contact the floor. Hard contact may
damage the connector.
NOTE: Guide the waterline and wiring harness
through hinge while lifting the door from hinge.
6. Open the door 90° and lift door straight up and
off the lower hinge.
GEA00908
Thimble
Hinge Pin
Torx Screw
Lower Hinge, Freezer Side
7. Remove the Torx screws (3) and the lower
hinge from the cabinet.
GEA00971
Torx Screw
Hinge
Adjustment
Pin
Hinge
Thimble
Lower Hinge, Fresh Food Side
Fresh Food Door Adjustment
IMPORTANT: The freezer door is not adjustable.
The fresh food door can be adjusted to match the
height of the freezer door.
IMPORTANT: The refrigerator rollers must be
adjusted correctly to ensure proper door closure.
Refer to the Roller Adjustment section in this
chapter for more information.
1. Remove the base grille.
2. Turn the hinge adjustment pin (located on the
fresh food lower hinge) clockwise to raise the
door level and counterclockwise to lower the
door.
Rollers
This unit has 4 rollers for easy movement of the
refrigerator. There are 2 rollers located in the front
and 2 rollers located in the rear of the unit.
IMPORTANT: The refrigerator rollers must be
adjusted properly to ensure proper door closure.
Refer to Roller Adjustment.
1. To remove the front rollers, back the level
adjusting screw all the way out.
2. Remove the 1/4-in. roller mounting screws and
remove the caster.
GEA00945
Screws
Screws
Screws
3. To remove the rear rollers, remove 1/4-in.
mounting screws (2).
4. Tilt the roller down and slide it out.