– 18 –
Dispenser LED Light
The LIGHT selection on the LCD screen turns the
dispenser LED lights on and off. When the light
selection is turned off, the LEDs will fade out. The
dispenser LEDs will come on automatically when
the dispenser cradle is pressed and will fade out
approximately 5 seconds after it is released. The
LIGHT selection will not turn off the LEDs during
dispensing.
Dispensing Functions
The water, crushed ice, and cubed ice functions
are controlled by the main control board. To select
a function, press the appropriate pad on the
dispenser. The LED will light to identify the selection.
To dispense ice cubes or crushed ice, choose the
appropriate pad and depress the dispenser cradle.
The solenoid and linkage assembly will open the ice
chute duct door to dispense the ice. If cubed ice is
selected, a solenoid located behind the ice bucket
will lift a rod along the side of the bucket. This rod
pulls a fl apper away from the cutter blades, allowing
cubes to bypass the ice crusher. The dispenser duct
door will remain open for approximately 3 seconds
after dispensing to allow all ice to clear the chute.
The dispenser light LEDs will come on automatically
when the dispenser cradle is pressed and will fade
out 5 seconds after it is released.
Dispenser Lock
When the dispenser system is locked, no dispenser
command will be accepted. This includes the
dispenser cradle and will prevent accidental
dispensing that may be caused by children or pets.
If the touch screen, pad, or the cradle is depressed
with the system locked, it will be acknowledged with
three pulses of the LOCK LED accompanied by an
audible tone.
To lock or unlock communication between the
dispenser and main control board, press the LOCK
pad and hold it for 3 seconds. The LOCK LED will
fl ash while the LOCK pad is pressed. When the
communication is locked, the LOCK LED will be
illuminated.
On some models, the status of other functions
selected prior to the initiation of the lock feature will
be displayed. If the lock is engaged while a mode is
active, the LED will remain on until that mode times
out.
If the lock is engaged when the fi lter timer expires,
the LED will come on but cannot be reset until the
lock is turned off.
The lock feature will be restored in the event of a
power disruption.
Liner Protection Mode
The dual evaporator model has separate liner
protection modes for each section. The specifi c
evaporator fan (freezer or fresh food) will start and
run on high speed if the door has been open for 3
minutes.
This mode is controlled by 2 timers. Timer #1
monitors door-open time. A 3-minute door-open
count begins when the door is opened. If 3 minutes
elapse before the door is closed, the liner protection
mode will become active. Once the door is closed,
timer #1 resets and liner protection mode goes into
standby. In standby, normal fan operation resumes
and timer #2 begins a 3-minute door-closed count.
If 3 minutes elapse without a door opening, liner
protection mode will completely deactivate. If a
door is opened within the timer #2 door-closed
count, the remaining time in the door-closed count
will be deducted from the timer #1 door-open count.
