– 26 –
Top Freezer Drawer
Freezer Basket
1. Open the top freezer drawer until it stops.
2. Lift the front end of the basket until the front
2 alignment tabs come out of the front plastic
inserts located in the slide assemblies.
3. Rotate the front edge of the drawer up while
lifting the remaining 2 rear alignment tabs out
of the rear plastic inserts located in the slide
assemblies. Pull the basket up and out of the
drawer.
Alignment Tab (1 of 4)
Plastic Insert
Slide Assembly
Drawer Vertical Adjustment
Note:
This following instruction is for adjusting the
upper drawer front vertically to meet appearance
needs of the customer. Both the right- and left-side
of the drawer front can be adjusted independently.
To adjust the drawer vertically:
1. Remove the freezer basket. (See Freezer Basket,
this section
.)
2. Remove the pilot screw on the side of the
drawer front that needs to be adjusted. Do one
side at a time if both need adjustment.
3. Loosen 3 full turns the remaining three 10-mm
hex-head screws on the side that needs to be
adjusted.
4. Raise or lower the side of the drawer front
requiring adjustment to the desired position.
Once positioned, tighten the 3 screws.
Note:
Do not replace the pilot screw once the
drawer front is adjusted. It is no longer needed.
Left Side Bracket Shown
Loosen
Pilot Screw
Remove
Do Not
Remove
Loosen
Loosen
Drawer Panel Removal
To remove the drawer panel:
1. Remove the freezer basket. (See Freezer Basket,
this section
.)
2. Remove the four 10-mm hex-head screws (4 on
each side) that attach the drawer panel to each
drawer bracket.
(
Continued next page
)
