– 18 –
You may find that your new oven cooks differently than the one it replaced. Use your new oven for a few weeks to
become more familiar with it. If you still think your new oven is too hot or too cold, you can adjust the thermostat
yourself.
Do not use thermometers, such as those found in grocery stores, to check the temperature setting of your oven.
These thermometers may vary 20–40 degrees.
NOTE:
This adjustment will only affect baking and roasting temperatures; it will not affect broiling, convection or
self-cleaning temperatures. The adjustment will be retained in memory after a power failure.
To Adjust the Thermostat
Touch the
BROIL HI/LO
and
BAKE
pads at the same time for 3 seconds
until the display shows
SF.
Touch the
BAKE
pad. A two digit
number shows in the display.
Touch
BAKE
again to alternate
between increasing and decreasing
the oven temperature.
The oven temperature can be
adjusted up to (+) 35ºF hotter or (-)
35ºF cooler. Touch the number pads
the same way you read them. For
example, to change the oven
temperature 15ºF, touch
1
and
5
.
When you have made the
adjustment, touch the
START
pad to
go back to the time of day display.
Use your oven as you would
normally.
+
The oven door must be closed and all controls set correctly for the cycle to work properly.
How to Set the Oven for Cleaning
Touch the
SELF CLEAN LO/STD
pad
once for a 4-hour clean time or
twice for a 3-hour clean time.
A 3-hour self-clean time is
recommended for use when
cleaning small, contained spills. A
self-clean time of 4 hours or longer
is recommended for a dirtier oven.
If a time other than 3 hours or
4 hours is needed, use the number
pads and enter the desired clean
time.
You can change the clean time to any
time between 3 hours and 5 hours,
depending on how dirty your oven is.
Touch the
START
pad.
The door locks automatically. The display
will show the clean time remaining. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the
LOCKED
light
goes off.
When the
LOCKED
light goes off, you will
be able to open the door.
■
The word
LOCKED
will flash and the
oven control will signal if you set the
clean cycle and forget to close the oven
door.
■
To stop a clean cycle, touch the
CLEAR/OFF
pad. When the
LOCKED
light
goes off indicating the oven has cooled
below the locking temperature, you
will be able to open the door.
Using the Self-Cleaning Oven
Adjusting the Oven Thermostat
Summary of Contents for Profile J2S968 SERIES
