– 22 –
Gas Conversion Range and Rangetop
TOOLS YOU NEEDED FOR CONVERSION
WARNING:
This conversion must
be performed by a qualified installer or gas supplier
in accordance with the manufacturer’s instructions
and all codes and requirements of the authority having
jurisdiction. Failure to follow instructions could result
in serious injury or property damage. The qualified
agency performing this work assumes responsibility
for the conversion.
WARNING:
The rangetop, as shipped from
the factory, is set for use with its intended gas. If you
wish to use your rangetop with the alternate gas, you
must first replace the orifices and convert the pressure
regulator.
WARNING:
The following adjustments must
be made before turning on the burner. Failure to do so
could result in serious injury. Be sure pressure regulator
has been converted as described in Step 2.
S
a
fety Gl
a
sses
S
ma
ll Fl
a
t
-
He
a
d Screwdriver
(2 to 2.4
mm
or 3/32" tip size,
60
mm
long)
Crescent Wrench
1/4"
a
nd 7
mm
Nutdrivers
S
ma
ll Pliers
1/2" Deepwell
Socket Wrench
Philips
Screwdriver
ORIFICE HOLDER
The range orifice holder
is located behind the front
access panel at the bottom
of the range.
The rangetop orifice holder
is located inside the range insulation cover.
Additional orifices may be present. Use only the orifices
specified in the instructions for your range or rangetop.
Griddle
Orifice
Grill
Orifice
B
urner Orifices
1
Attach the Anti-Tip Brace onto the bottom of the
range in the recessed area. Install 2 hex screws
(provided) through the brace and into the range.
Note:
This Anti-Tip device may be installed on the
opposite side of the range.
Altern
a
te
B
r
a
ce
Position
Hex Screws
Anti
-
Tip
B
r
a
ce
Measure and mark Dimension A (see table
1.
below) from the left (or right) side of the
installation location. If the countertop has an
overhang, add that dimension to Dimension A.
Place the Anti-Tip Bracket against the
fl
oor and
2.
back wall at the marked location. Mark screw
holes for fastening the bracket to the wall sole
plate and the
fl
oor.
Drill 1/8" pilot holes at a 20° angle.
3.
Secure the bracket to the wall and/or
fl
oor with
4.
at least 2 wood screws (provided).
For Concrete or Cement Construction:
You must
use appropriate fastening hardware (not provided).
Range
A
30"
5-1/16"
36"
5-1/16"
48"
8-1/4"
Anti
-
Tip
B
r
a
cket
A
W
a
ll Sole Pl
a
te
