58
5.2.38.5 Remove the two 3/16" Quick Connect terminals
from the terminals of the light holder.
5.2.38.6 To remove the reflector from the light body and
holder, simply pry the reflector retainer clips from the three
cut outs of the light body and holder.
NOTE: The three reflector retainer clips are positioned with
two retainer clips adjacent to each side of the lamp holder,
while the third retainer is adjacent to the tip of the light bulb.
5.2.38.7 Removal of the light body and holder can be carried
out simply by releasing one of the locking nuts and unscrew-
ing the locking nut from the lamp holder body.
NOTE: The internal locking nut adjacent to the light lens has
a fixed position of approximately two threads projecting past
the face of the locking nut. This relationship should be
maintained for ease of removal/ reinstallation of the light
globe.
5.2.38.8 Reinstallation of the interior lamp assembly is a
reversal of removal and dismantling of the lamp body and
holder assembly.
5.2.38.9 Reassemble the dishwasher in reverse order.
CAUTION. Test for water leaks before leaving.
5.2.38.10 Operate and test the dishwasher before leaving.
5.2.38 Interior Light - 5700 & 5900 Models only
NOTE: The 5600 model (Rotary Control) is not fitted
with an interior light.
CAUTION. Switch off electrical power supply
and turn off water supply at main or
dishwasher shutoff.
5.2.38.1 Unscrew the light lens and seal from within the
dishwasher tub.
5.2.38.2 To remove the light body and holder, simply unlatch
the retaining barb clip with a medium size screwdriver as
shown below.
Unlatch barb clip with medium size screwdriver
5.2.38.3 With the barb clip released, a slight pressure on the
opposite barb clip will allow the light body and holder to be
removed from the tub. Shown below.
5.2.38.4 To access the wiring connections to the light holder,
pry the single barb clip (below) from the terminal cover and
lift clear the terminal cover.
Light body and holder
Terminal cover barb clip
Light lens and seal
