MDS 05-2818A01, Rev. C
MDS P-60/P-60 HL Reference Manual
27
Invisible place holder
Figure 12. MDS P-50 Mounting Dimensions
Wall Mounting Instructions
The steps below describe mounting of the MDS
P-50
unit to a wall or other flat
surface. Ordinary lag screws (with flat washers) can be used if the unit is to be
mounted to a wooden surface. If it is to be mounted to a drywall, masonry or
other non-wooden surface, suitable fasteners will be required that can support
the weight of the unit.
To wall mount the unit, follow these instructions:
1. Hold the packaged unit up to the wall in the desired mounting
position. Have an assistant mark the four mounting holes with a
pencil or marker.
2. Prepare the mounting surface for the fasteners to be used. (If using lag
screws, a small pilot hole at each mark will allow easier starting of the
screw.)
3. Hold the packaged unit up to the wall again while an assistant installs the
four mounting screws. Make sure the screws are tightened securely, but do
not over-tighten.
Figure 13 on Page 28
shows a typical wall mount installation.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8466-MDS-P60-Compact-Enclosure-(One-Radio).aspx