GE LM10, Instruction Manual

Page: 62 / 106

5–56 LM10 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
DEVICENET OPERATIONS CHAPTER 5: COMMUNICATIONS
The data type format codes for class code 0x64, instance 1 are shown below.
0x09 Get/set User setting, Run 2, stall F4 Trip, Time
0x0A Get/set User setting, Run 1, unbalance F5 Trip, Time
0x0B Get/set User setting, Run 2, unbalance F5 Trip, Time
0x0C Get/set User setting, Run 1, load loss F6 Trip, Time
0x0D Get/set User setting, Run 2, load loss F6 Trip, Time
0x0E Get/set User setting, power transformers F7 0 to 11
0x0F Get/set User setting, current transformers F8 1 to 15
0x10 Get/set User setting, auxiliary sense 1 timer F9 0.1 × (0 to 250)
0x11 Get/set User setting, auxiliary sense 2 timer F10 0.1 × (0 to 250)
0x12 Get/set User setting, auxiliary relay flags F11 16 bits
0x15 Get Motor run time hours UINT Hours
0x1A Get/set Configure passcode UINT Code (0)
0x24 Get/set User setting, motor type F12 Type 0 to 5
0x25 Get/set User setting, loops through CT F13 1 to 4
0x26 Get/set Flags (Mrun, AutoRestart, O/V Volt
Enable, DNFault, 50 Hz)
F14 16 bits
0x2E Call Reset LM10
*
N/A ---
0x1C Call Reset factory default user settings N/A ---
0x2F Get Trip class F17 ---
0x30 Get MAC ID F18 ---
0x31 Get DeviceNet baud rate F19 ---
0x34 Get Input switch status F25 16 bits
0x38 Get Remaining cool-down period F26 16 bits
0x39 Get/set Poll data group F15 1 to 4
0x3A Get/set Run1-Run2 time delay F16 0 to 600 sec.
0x3B Get/set Run2-Run1 time delay
2
F16 0 to 600 sec.
0x40 History Status (send data byte 0 for current, 1
to 10 for history)
F24 ---
0x41 History Phase A current F23 × 0.1 A
0x42 History Phase B current F23 × 0.1 A
0x43 History Phase C current F23 × 0.1 A
0x44 History Ground current F23 × 0.1 A
0x45 History Voltage UINT volts
0x46 History Power factor UINT percent
0x47 History Watts F23 0.1 kW
0x48 History Operating current F23 × 0.1 A
0x49 History Current unbalance UINT percent
0x50 Login User --- ---
0x51 Login Configuration UINT Passcode
0x52 Login Calibration UINT Passcode
*This call function has the same result as pressing the Reset key on the PDU display
Applies to revisions 1.50 and higher
Attribute Access Name/Description Data Type Value