GE Legend IP, User Manual

Page: 109 / 140

Chapter 6
System operation
101
Rebooting versus resetting a dome
Rebooting a dome requires that you have valid communication between the keypad and the dome. You can
reset a dome with or without valid communication between the keypad and dome.
Rebooting the dome
You cannot currently reboot Legend IP domes from other keypads.
To reboot a dome, do the following from the KTD-405 keypad:
1. At the normal display (CAMERA #/MONITOR #), press and hold the set ( ) key on the keypad until
you hear a beep and the programming code display appears on the keypad’s LCD.
2. At the ENTER PROGRAMMING CODE: display, enter the reset access code by pressing the 1 , 4 , 7 , 6 ,
and seq keys.
3. At the RESET TO DEFAULTS? display, press iris + for yes.
4. At the display that asks what to reset, press 3 to select CAMERA.
5. At the RESET CAMERA #? ARE YOU SURE? display, press iris + to select yes.
The camera reboots in about 60 seconds. You will see the RESETTING CAMERA # display on the
keypad LCD and the color bars and splash screen on the monitor screen as the camera reinitializes itself.
Resetting the dome
You can reset the dome temporarily to factory defaults, whether or not you have communications with the
dome. This will temporarily apply factory defaults to all the settings, including the IP address and subnet mask.
Once the dome has entered this state, you can connect to it using the default IP address of 192.168.1.2/
255.255.255.0.
To reset the dome, do the following:
1. Disconnect power to the dome in question for 20 seconds.
2. Reapply power to the dome in question for 20 seconds.
3. Repeat steps 1 and 2 four more times to make a total of 5 power cycles.
4. When the dome is powered up after the fifth power cycle, it will have the factory defaults for all the
settings. Make any necessary changes to the dome’s programming.
5. After you’ve made your changes, power cycle the dome again. You’re new settings will take effect,
along with any settings that weren’t changed in step 4, which will return to whatever they were before
you reset the dome.
Note: Some auxiliary settings are related to primary settings. If you changed a primary setting that is related to an
auxiliary setting, even if you didn’t change the auxiliary setting, the primary setting may have affected it and it
will be changed when you power cycle the dome.