GE JV347IFWW, Owner'S Manual And Installation Instructions, Page: 10 / 14

10
REMOVE EXHAUST ADAPTOR
If exhausting/venting using the 3
1
⁄
4
″ x 10 ″ rectangular
duct
Remove the exhaust adaptor from the inside of the hood.
Set it aside along with its mounting screws .
3
1
⁄
4
″ x 10 ″
rectangular
exhaust
adaptor
and screws
REMOVE FILTER
Remove the shipping tape holding the metal grease
filter in place . Pull down on the center of the front edge
of the filter . The filter will then slip out of the retaining
tabs on the back .
REVERSE THE BAFFLE FOR
DUCTED INSTALLATIONS ONLY
If the hood is to be recirculated, skip to the next step.
Remove the baffle from the top of the hood . Reinstall
the baffle so the short side marked “VENTED” is visible .
The long side of the baffle should be inside the hood .
2
3
4
Metal grease filter
Installation Instructions
“VENTED” is visible
REMOVE DUCT KNOCKOUT
If recirculating , non-vented ductless
skip to Step 9 D and proceed.
Using a flat-blade screwdriver, remove the appropriate
duct knockout from the top or back of the hood .
3
1
⁄
4
″
x 10
″
Rectangular
vertical discharge.
Remove top rectangular
duct knockout only .
7 ″ Round vertical discharge.
Remove circular duct
knockout only .
3
1
⁄
4
″ x 10 ″ Rectangular horizontal
discharge. Remove rear
rectangular duct knockout only .
5