Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Make sure the clock is set to the
correct time of day.
The Timer is a minute timer only.
The Timer does not control oven
operations. The maximum setting on
the Timer is 9 hours and 59 minutes.
Using the clock, timer and control lockout.
www.GEAppliances.ca
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Touch the
CLOCK
pad.
Touch the number pads.
Touch the
START
pad.
To Set the Timer
Touch the
TIMER
pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch
2, 4
and
5
in that order. If you make a
mistake touch the
TIMER
pad and
begin again.
Touch the
START
pad.
After touching the
START
pad,
SET
disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the Timer reaches
:00
, the
control will beep 3 times followed
by one beep every 6 seconds until
the
TIMER
pad is touched.
The 6-second tone can be canceled by following
the steps in the Special Features of Your Oven
Control section under Tones at the End of a
Timed Cycle.
To Reset the Timer
If the display is still showing the
time remaining, you may change it by
touching the
TIMER
pad, then touch the
number pads until the time you want
appears in the display.
If the remaining time is not in the
display (clock, start time or cook time
are in the display), recall the remaining
time by touching the
TIMER
pad and
then touching the number pads to
enter the new time you want.
To Cancel the Timer
Touch the
TIMER
pad twice.
Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the touch pad controls:
Touch and hold the
9
and
0
pads
at the same time until the control
beeps.
The oven display will show
Loc On
for several seconds, then it will go
blank until a cooking pad is touched.
To unlock the control, touch and
hold the
9
and
0
pads at the same
time until the control beeps.
If the range control is locked and a
cooking pad is touched, the oven display
will show that the control is locked.
■
On models with
CONTROL LOCKOUT
only,
the oven will be locked out. The knob-controlled
surface units will still be active.
Control Lockout
(on some models)
15
Summary of Contents for JCB909
Page 46: ...46 ...
