49-60807 Rev. 3
13
INST
ALLA
TION INSTRUCTIONS
Installation Instructions
INSTALLING THE WATER LINE (Continued)
,I\RXUH[LVWLQJFRSSHUZDWHUOLQHKDVDIODUHGILWWLQJ
at the end, you will need an adapter (available at
SOXPELQJVXSSO\VWRUHVWRFRQQHFWWKHZDWHUOLQHWR
WKHUHIULJHUDWRU25\RXFDQFXWRIIWKHIODUHGILWWLQJ
with a tube cutter and then use a compression
ILWWLQJ'RQRWFXWIRUPHGHQGIURP6PDUW&RQQHFW
5HIULJHUDWRUWXELQJ
6KXWRIIYDOYHWRFRQQHFWWRWKHFROGZDWHUOLQH
The shutoff valve should have a water inlet with
a minimum inside diameter of 5/32” at the point of
FRQQHFWLRQWRWKH&2/':$7(5/,1(6DGGOHW\SH
shutoff valves are included in many water supply
kits. Before purchasing, make sure a saddle-type
valve complies with your local plumbing codes.
WHAT YOU WILL NEED
(CONT.)
SHUT OFF THE MAIN WATER
SUPPLY
Turn on the nearest faucet long enough to clear
the line of water.
,QVWDOOWKHVKXWRIIYDOYHRQWKHQHDUHVWIUHTXHQWO\XVHG
drinking water line.
1
&KRRVHDORFDWLRQIRUWKHYDOYHWKDWLVHDVLO\
DFFHVVLEOH,WLVEHVWWRFRQQHFWLQWRWKHVLGH
of a vertical water pipe. When it is necessary
to connect into a horizontal water pipe, make the
connection to the top or side, rather than at the
bottom, to avoid drawing off any sediment from
the water pipe.
CHOOSE THE VALVE LOCATION
2
DRILL THE HOLE FOR THE
VALVE
3
Drill a 1/4” hole in the water pipe (even if using
DVHOISLHUFLQJYDOYHXVLQJDVKDUSELW5HPRYH
any burrs resulting from drilling the hole in
the pipe.
Take care not to allow water to drain into
the drill.
Failure to drill a 1/4” hole may result in reduced
ice production or smaller cubes.
Fasten the shutoff valve to the cold water pipe
with the pipe clamp.
NOTE:
&RPPRQZHDOWKRI0DVVDFKXVHWWV
3OXPELQJ&RGHV&05VKDOOEHDGKHUHGWR
6DGGOHYDOYHVDUHLOOHJDODQGXVHLVQRWSHUPLWWHG
LQ0DVVDFKXVHWWV&RQVXOWZLWK\RXUOLFHQVHG
plumber.
FASTEN THE SHUTOFF VALVE
4
3LSH&ODPS
9HUWLFDO&ROG
Water Pipe
6DGGOH7\SH
6KXWRႇ9DOYH
