GE IC754VGI06SKD, User Manual

Page: 6 / 78

consumer to:
(i) Encode video in compliance with the standards licensed under such patent portfolio
licenses and/or
(ii) Decode video that was encoded by a consumer engaged in a personal and non-commercial
activity and/or was obtained from a video provider licensed to provide video under such patent
portfolio licenses.
Such license extends to this product only and only to the extent of other notices which may be
included in this document. The license does not extend to any other product regardless of
whether such product is included with this licensed product in a single article. No license is
granted or shall be implied for any other use. Additional information may be obtained from
MPEG LA, L.L.C. See http://www.mpegla.com.
The FCC requires the following note to be published according to FCC guidelines:
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Any changes or modifications to the product or installation that are not expressly approved by
GE
Intelligent Platforms
could void the user's authority to operate the equipment under FCC
rules.
Industry Canada requires the following note to be published:
This Class A digital apparatus complies with Canadian ICES-003.
The following statements are required to appear for Class I Div 2 Hazardous Locations.
1. WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY IMPAIR
SUITABILITY FOR CLASS 1, DIV. 2.
2. WARNING - EXPLOSION HAZARD - WHEN IN HAZARDOUS LOCATIONS, TURN OFF
POWER BEFORE REPLACING OR WIRING MODULES.
3. WARNING - EXPLOSION HAZARD - DO NOT CONNECT OR DISCONNECT
EQUIPMENT UNLESS POWER HAS BEEN SWITCHED OFF OR AREA IS KNOWN TO BE
NON-HARZARDOUS.
Power, input and output (I/O) wiring must be in accordance with Class I, Division 2 wiring
methods, Article 501 4(b) of the National Electric Code, NFPA 70 and in accordance with the
authority having jurisdiction.
For a complete list of agency qualifications, please refer to Appendix A1.
We want to hear from you. If you have any comments, questions, or suggestions about our
documentation, send them to the following email address:
support.ip@ge.com
.