32
Setting the Program
3
Choosing a program:
Water Clarity
Advanced Plus Controller
Low Turbidity
less than 0.5 NTU
Program 1
Medium Turbidity
Peaks to 1.0 NTU, less than 72
min. per day
Program 2
High Turbidity
Peaks to 5.0 NTU, less than 72
min. per day
Program 3
Very High Turbidity
Peaks to 10.0 NTU, less than 72
min. per day
Program 4
NOTE:
If surface water is the source, select either Program 3
or Program 4 in this application.
Advanced
Plus
Controller
Cleaning
Sequence
Duration
Approx Water
Consumption Per
Cleaning Cycle at 5
gpm
Program 1
2 flushes
2.5 min
7.5 gal
Program 2
4 flushes
6 min
15 gal
Program 3
2 flushes & 1
drain
8.5 min
13.5 gal
Program 4
2 flushes & 2
drains
16.5 min
19.5 gal
figure 58
1)
Press NEXT four times until “PROGRAM” flashes on
screen. Press eNTeR.
3)
Press the UP and DOWN arrows to set the Program
number. Select the appropriate Program for your
application. Press ENTER.
Setting the Controller
NOTE:
Electrical power to the controller must be ON to
activate the flushing and draining sequences. The batteries
are for keeping the time in case of power failure and will not
activate the flushing and draining sequences.
NOTE:
Once the controller is set, the controller will remember
the start time, program number, and flush/drain interval
settings (if applicable) even if the electrical power to the
controller is interrupted.
NOTE:
When the system is undergoing a flushing or a draining
sequence, very little or no water will be available for use in the
dwelling. If possible, select a time for the flushing and draining
when no water generation is required. Normal operation will
resume once the flushing and draining sequences are finished.
Follow these steps to set the Controller:
Setting the Clock
1
figure 56
1)
Press NEXT twice until “SET TIME” flashes on screen.
Press eNTeR.
2)
Press the UP and DOWN arrows to set the hour. Press
eNTeR.
3)
Press the UP and DOWN arrows to set the minute. Press
eNTeR.
Setting Flush/Drain Time
2
figure 57
1)
Press NEXT three times until “START TIME” flashes on
screen. Press eNTeR.
2)
Press the UP and DOWN arrows to set the hour. Press
eNTeR.
3)
Press the UP and DOWN arrows to set the minute. Press
eNTeR.
NOTE:
Select a time that water usage is not expected in the
dwelling. (e.g. 2:00 a.m.). Check with homeowner.
