GE GTRS0 Series, Technical Service Manual

Page: 30 / 63

– 16 –
Door Gaskets
The fresh food and freezer doors have magnetic
gaskets that create a positive seal to the front of
the steel cabinet. The magnetic door gaskets
are secured to the fresh food and freezer doors
by a barbed edge that locks into a retainer
channel.
1. Starting at any corner, pull the old gasket out
of the retainer channel.
2. Soak the new gasket in warm water to make
it pliable.
3. Push the barbed edge of the gasket into the
retainer channel.
GEA01150
Rollers
Rollers at the base of the cabinet enable the
customer to easily move the refrigerator.
Cabinet leveling is done by adjusting the front
rollers. To adjust the front rollers, use a 3/8-in.
socket or a large flat head screwdriver to turn
the roller adjustment screws located behind the
base grille. The rear rollers are not adjustable.
To remove a front roller assembly from the base
of the cabinet:
1. Tilt the cabinet back and place a
3-in. block under the side of the unit.
2. Remove 3 hex head 1/4-in. screws from the
roller assembly.
3. Loosen the adjustment screw until it
disengages from the assembly and remove
the assembly from the cabinet.
4. Remove the E-ring to remove the
adjustment screw from the base channel.
Note:
When reinstalling the roller assembly,
position the nut with the flared thread toward the
rear of the unit.
GEA01147