– 24 –
Door Switch Assembly
The door switch assembly is activated by a spring-
loaded plunger that connects or disconnects the line
(hot) side of 120 VAC.
When the door is in the closed position, the door
latch presses and holds down the switch plunger on
the door switch assembly. This action holds the door
fi rmly against the seal, with the contacts of the door
switch closed.
To remove the door switch assembly:
1. Disconnect the power supply to the dishwasher.
2. Remove the outer door panel. (See
Outer Door
Panel
.)
4. Remove the 3 Phillips-head screws from the
door switch.
Door Handle
The door handle is held in place by 2 screws that
can be accessed by removing the console.
To remove the door handle:
1. Remove the console. (See
Lens
, steps 1-3.)
2. Remove the two 1/4-in. hex-head screws
holding the handle to the outer door (1 on each
side).
Disconnect
Disconnect
Detergent/Rinse Module
The inner door panel must be removed to access
the detergent/rinse module. (See
Inner Door Panel.
)
The detergent/rinse module is connected by 2 wires
and held in place by 6 Phillips-head screws and a
bracket.
The detergent/rinse module operates on 120 VAC
and has an approximate resistance value of 1.2 to
2.8 K
Bracket
(Continued next page)
3. Disconnect the 2 wires from the door switch.