24
SD Series Reference Manual (x710 Mode)
MDS 05-4670A01, Rev. E
6.2 Detailed Command Descriptions
The only
critical commands for most applications are transmit and
receive frequencies (
TX xxx.xxxx, RX xxx.xxxx
) and Modem configuration
(
MODEM xxxx
) settings. However, proper use of the additional commands
allows you to tailor the transceiver for a specific use, or conduct basic
diagnostics on the radio. This section provides detailed information for
the user commands previously listed in Table 11 (Page 21).
Set/display the custom receive tolerance to
accommodate issues experienced with some
x790 masters.
Set/display the value of the receive time-out timer.
Saves a user configuration.
Set/display the Soft-Carrier Dekey delay in
milliseconds.
Display the radio serial number.
Display the DC voltages and transmit power level.
Signal-to-Noise Ratio, expressed in dB.
Display the transceiver’s built-in spectrum
analyzer, where xxx.xx denotes center frequency.
Set/display analog squelch bypass.
Display the Software Revision Level.
Display radio status and alarms.
Switched Carrier configuration.
Set/display all TFTP settings.
Display the internal temperature of the radio in
degrees C.
Set/display the Time-out Timer delay in seconds.
Set/display the transmit frequency.
Set/display the transmit audio input level.
Set/display the transceiver’s unit address.
Displays time since last system reboot.
Displays firmware package information.
Table 11. Command Summary
(Continued)
Command name
Function
Summary of Contents for DS-SD4-1
Page 10: ...viii SD Series Reference Manual x710 Mode MDS 05 4670A01 Rev E ...
Page 69: ...MDS 05 4670A01 Rev E SD Series Reference Manual x710 Mode 59 NOTES ...
Page 70: ...60 SD Series Reference Manual x710 Mode MDS 05 4670A01 Rev E ...
Page 74: ...MDS 05 4670A01 Rev E SD Series Reference Manual x710 Mode I 4 ...