Chapter 3: Programming
36
Concord 4 Installation Manual
System programming
Use this setting to access the tier 2 programming menus. (See “Tier 2
programming menus” on page 37.)
Demo kit mode
Default = Off
This setting determines whether you use your panel for a standard installation
(off) or as a demo kit (on). When the demo kit option is on, only sensors learned
into groups 01 and 03, duress code use, and phone test (8,
system master
code
, 2) are reported. Turning on this feature and doing a memory clear
changes the following settings:
Partition 1 master code = 1000
Partition 2 master code = 2000
User code 00 = 1001 (partition 1 code – you may use to jump to partition 2)
User code 01 = 1002 (partition 1 code – you may use to bypass sensors)
User code 02 = 2001 (partition 2 code – you may use for remote or offsite
access)
User code 03 = 2002 (partition 2 code – you may use to perform system tests)
User code 04 = 1122 (partition 1 code – you may use to jump to partition 2, for
remote or offsite access, and system tests)
User code 05 = 2233 (partition 2 code – you may use to jump to partition 1, for
remote or offsite access, bypassing sensors, and system tests)
Partition 1 house code = 255 (P)
Partition 2 house code = 254 (O)
Zone 1 (hardwired input 1) = Group 10, front door
Zone 2 (hardwired input 2) = Group 13, bedroom window
Zone 3 (hardwired input 3) = Group 17, living room motion sensor
Zone 4 (hardwired input 4) = Group 1, panic
Zone 5 (wireless keyfob, ID F00201) = Group 01, (no text)
Zone 6 (wireless DWS, ID A00206) = Group 13, kitchen window
Com failure = off, Demo kit = on
AVM code = 1212
Entry delay = 8 seconds
Exit delay = 8 seconds
Extended delay = 1 minute
Siren timeout = 2 minutes
To turn demo kit mode off or on:
1. With the display showing
DEMO KIT MODE OFF/ON
(current setting),
press 1
(off) or 2
(on). The display flashes the entered setting.
2. Press #. The display shows
DEMO KIT MODE OFF/ON
(new setting).
Partition 1 copy
Default = None
After programming all settings pertaining to partition 1, you may make an
exact copy to use for partitions 2 to 6. This helps reduce programming time
when the system is set up for multiple partitions. If there are certain settings
that are unique to partitions 2 to 6, simply advance to the appropriate menu
and make the necessary changes.
To copy partition 1:
1. With the display showing
PARTITION 1 COPY,
press #,
installer code
, #.
The display flashes.
2. Press #. The display shows
DONE
.
